Warning

Binding to a pin without a physical button and pull-down resistor connected may put FarmBot into an unstable state.

pin_bindings.png

v1.4 stock bindings shown

Set or remove Raspberry Pi GPIO pin bindings to allow start of a sequence or an action by pressing a physical button (or by motion sensor output).

Select a Raspberry Pi GPIO pin number (open the GPIO diagram for assistance as shown below by pressing the icon) and select a sequence in the drop down menu.

pin_bindings_gpio.png

Alternatively, select an action:

pin_bindings_action.png

When done press BIND to save the binding.

Notes:

  • Sequences must be synced to the device before use in a pin binding.
  • Buttons should be connected between the selected pin and +3.3v.